Published
This video I configure Breakout mode 10g-4x for interface port group 1/1/6 which compose of port eth1/1/21-24.
10g-4x — Split a QSFP28 or QSFP+ port into four 10G interfaces
10g-4x — Split a QSFP28 or QSFP+ port into four 10G interfaces
- Category
- Routers and Switches
Be the first to comment
Up Next
Autoplay
-
24:01
Install OS10 on Dell Force10 Switch S4048-ON
-
07:32
Bundle Mode or Install Mode: How to Upgrade your Cisco IOS Switch
-
12:18
How to configure an OmniSwitch 6900 from Standalone to Virtual Chassis mode
-
07:14
Single mode Vs Multi mode Fiber Cable | Network Engineer Must Know this
-
03:15
Configure General Mode Interfaces on Your N-Series Switch
-
23:15
Alcatel Lucent ONT Configure via AMS 5520 GUI mode Untag Access port
-
10:52
Setting User Mode and Privileged Mode Password on Cisco Switch Router IOS
-
02:15
Configure Access Mode Interfaces on Your N-Series Switch
-
03:50
Actualizacion SO Switch Dell Force10 S50 and S25
-
05:31
Avaya IP Office - How to Switch Basic Mode to Standard Mode
-
01:59
QSFP28 100G Optical Transceivers in the New Data Center
-
25:20
How much is a 100G QSFP28 transceiver?
-
02:50
How about the feature of QSFP28 QSFP+ SFP+ XFP CWDM DWDM BIDI module? (LD, PD, Tx Power, Rx Sens )
-
02:21
Finisar Demonstrates 100G QSFP28 ER4f Transceiver at ECOC 2017
-
02:12
QSFP28 100G testing between Arista and Huawei
-
01:59
QSFP28 100G Transceivers in the New Data Center
-
04:34
Unboxing and Replace QSFP Broken || JNP QSFP 100G SR4 || SFP Module || Juniper
-
08:25
100G Transceivers Development
-
02:07
QSFP28 100G Transceivers: Key Features and Applications
-
04:09
Finisar QSFP28 Family Transceiver Demonstration at OFC 2015
